MATLAB SIMPOWERSYSTEMS 5 Manual de usuario descargar pdf (Pagina 19)

Palestine Polytechnic University

Workshop Matlab/Simulink in Drives and Power electronics – Lecture 418-21 May 2009

/ 20

The Powergui Block to Simulate

• The Powergui block is necessary to simulate any Simulink

model containing SimPowerSystems blocks.

– It is used to store the equivalent Simulink circuit that represents the state-

space equations of the SimPowerSystems blocks.

• You must follow these rules when using this block in a model:

– Place the Powergui block at the top level of diagram for optimal performance.

However, you can place it anywhere inside subsystems for your convenience;

its functionality will not be affected.

– Only one Powergui block per model

– You must name the block powergui

The Most used Simulation type are:

- Continous for Physical System

- Discrete for Commutating system

1 2 ... 14 15 16 17 18 19 20

Sin comentarios

MATLAB SIMPOWERSYSTEMS 5 Manual de usuario Pagina 19